Samsung HT-D5100-ZC - Manual (Page 37)

English
37
03
Setup
Settings
Display
Audio
Network
System
Language
Security
General
Support
IP Settings
> Move " Enter ' Return
IP Mode Manual
IP Address 0 . 0 . 0 . 0
Subnet Mask 0 . 0 . 0 . 0
Gateway 0 . 0 . 0 . 0
DNS Mode Manual
DNS Server 0 . 0 . 0 . 0
OK
Press the ENTER button to select IP Mode.
Press the ▲▼ buttons to select Manual,
and then press the ENTER button.
Press the ▼ button to go to the fi rst entry
fi eld (IP Address).
Use the number buttons on your remote to
enter numbers.
When done with each fi eld, press the ►
button to move successively to the next fi eld.
You can also use the other arrow buttons to
move up, down, and back.
Enter the IP Address, Subnet Mask, and
Gateway values.
Press the ▼ button to go to DNS Mode.
Press the ▼ button to go to the fi rst DNS
entry fi eld. Enter the numbers as above.
Press the ENTER button to select OK.
The Network Status screen appears. The
product connects to the network after the
network connection is verifi ed.
Wireless Network
You can setup a wireless network three ways:
Wireless (General)
Using WPS(PBC).
One Foot Connection
Wireless (General) includes both Automatic and
Manual setup procedures.
3.
4.
5.
6.
7.
8.
9.
10.
11.
•
•
•
Setting Up the Wireless Network Connection
- Auto
Most wireless networks have an optional security
system that requires devices that access the
network to transmit an encrypted security code
called an Access or Security Key. The Security
Key is based on a Pass Phrase, typically a word
or a series of letters and numbers of a specifi ed
length you were asked to enter when you set up
security for your wireless network. If you use this
method of setting up the network connection,
and have a Security Key for your wireless
network, you will have to enter the Pass Phrase
during the Auto setup process.
Press the ▲▼ buttons to select Wireless
(General).
Settings
Display
Audio
Network
System
Language
Security
General
Support
Network Settings
> Move " Enter ' Return
Wireless
(General)
One Foot
Connection
WPS(PBC)
Wired
Select a network connection type.
Set up wireless network by selecting your Wireless
Router. You may need to enter security key depending
on the setting of the Wireless Router.
Press the ENTER button.
When done, it displays a list of the available
networks.
Press the ▲▼ buttons to select the desired
network, and then press the ENTER button.
The Security screen appears.
On the Security screen, enter your network’s
Pass Phrase. Enter numbers directly using
your remote control.
To select a letter, press the ▲▼◄► buttons
to move the cursor, then press the ENTER
button.
1.
2.
3.
4.
HT-D5100_XAA_1224.indd 37 HT-D5100_XAA_1224.indd 37 2011-12-24 12:31:01 2011-12-24 12:31:01