Low battery indicator, Activating your phone, Turning your phone on – Samsung SECR300ZRAMTR User Manual
Page 9
Getting Started 9
1.
Plug the large end of the Travel Adapter into a standard
120 VAC or 220 VAC wall outlet.
Important!: For connection to an electrical supply not located in North America,
you must use an adaptor of the proper configuration for the power
outlet. Use of the wrong adapter could damage your phone and void
your warranty.
2.
Insert the smaller end
of the Travel Adapter
into the charger/
accessory connector on
the right side of your
phone.
Important!: You must unplug the adapter before removing the battery from the
phone during charging to avoid damage.
Low Battery Indicator
The battery indicator (
) in the upper-right corner of the
display indicates power level. Monitor the battery strength and
ensure your battery is adequately charged.
Three bars (
) indicate a full charge.
An empty battery icon (
) indicates a near empty battery.
A blinking empty battery icon (
) and a tone sounding
indicate you have two to three minutes before the battery is too
low to operate the phone.
If you continue to use your phone without charging its battery, the
phone will shut down.
Activating Your Phone
Contact your Wireless Carrier and follow their instructions for
obtaining service, if necessary. We suggest that you read this
guide to fully understand the services your phone supports.
Turning Your Phone On
ᮣ
Press and hold
until the display lights.
Note: As with any other radio-transmitting device, do not touch the antenna while
using your phone as this can affect call quality and can cause the phone to
operate at a higher power level than is necessary.
• The phone begins searching for a network signal.
• Once the phone finds a signal, the time, date, and day appear in the
bottom of the display.
• You’re now ready to place and receive calls.
Note: If you are outside of your carrier’s coverage or roaming area, the No Service
icon () appears at the top of the phone’s display. If you cannot place or
receive calls, try later when service is available, or at another location.
Correct
Incorrect