Installing the driver locally, Windows – Samsung SCX-3405W-XAC User Manual
Page 30
30
1. Introduction
Installing the driver locally
A locally connected machine is a machine directly attached to your computer
using the cable. If your machine is attached to a network, skip the following
steps below and go on to installing a network connected machine’s driver (see
"Installing driver over the network" on page 144).
•
If you are a Macintosh or Linux operating systems user, refer to the
"Installation for Macintosh" on page 134
•
The installation window in this
User’s Guide
may differ depending on the
machine and interface in use.
•
Selecting
Custom Installation
allows you to choose which programs to
install.
•
Only use a USB cable no longer than 3 meters (118 inches).
15
Windows
1
Make sure that the machine is connected to your computer and
powered on.
If the “Found New Hardware Wizard” appears during the installation
procedure, click Cancel to close the window.
2
Insert the supplied software CD into your CD-ROM drive.
If the installation window does not appear, click Start > All programs >
Accessories > Run.
X:\Setup.exe replacing “X” with the letter, which represents your CD-
ROM drive and click OK.
3
Select Install Now.
4
Read the License Agreement, and select I accept the terms of the
License Agreement. Then, click Next.
5
Follow the instructions in the installation window.