Samsung WAM250-ZA - Manual

Wireless Audio - Multiroom
HUB
Quick Setup Guide
A
Front Panel
1
This indicator turns on when power is supplied to the HUB.
2
This indicator blinks when the HUB is in pairing mode.
After pairing is complete, this indicator stops flashing and operates in normal mode.
Pairing mode continues for a set time period. The indicator may keep blinking after pairing is
completed.
3
This indicator turns on when the HUB is connected to a wireless router with an Ethernet cable.
4
This indicator turns on when the HUB is set to Repeater mode and used to expand wireless Wi-Fi
coverage in a network that includes another HUB and a wireless router.
If you have trouble connecting the HUB and M7 because the signal is blocked or the distance
between them is too great, add a new HUB in Repeater mode to expand wireless coverage.
A
What’s included
LAN cable
(AK39-00176A)
Power Adaptor
(BN44-00673A)
Quick Guide
(AH68-02665J)
A
Connecting the HUB to Your Wi-Fi Network
• M7s can be used anywhere your Wi-Fi signal reaches.
➜
➜
LAN
1 Connect the HUB to your router or modem using a
LAN cable.
Plug
In
2 Plug the included power cable into the back of
the HUB, and then plug the power cord into a wall
socket.
Plug
In
3 After the Pairing Indicator on the HUB lights, plug in the M7.
(For more information, see the M7 Quick Setup Guide.)
q w e r
A
Rear Panel
1
SPK ADD
Press this button to set the HUB to Pairing mode when adding an additional M7 or
to switch the HUB to Repeater mode.
(Press and hold for 1 second to switch to Pairing mode. Press and hold for 10
seconds to switch to Repeater mode.)
2
SERVICE
Used to update the firmware.
The SERVICE port is only for updating.
3
ETHERNET SWITCH
Used to connect a LAN cable.
If you want to connect another wired device to the router that the HUB is
connected to, and all the router’s wired ports are occupied, you can connect it
to an unoccupied LAN port on the HUB.
Connecting to the HUB provides the same functionality as being connected to the
router. However, the link to the router will be lost if you power off (unplug) the HUB.
Note : The HUB and the router must have a hard-wired connection.
4
RESET Press the RESET button with a pen tip for 5 seconds to reset the HUB.
5
DC IN Connector for the power cable.
w q e r t
WAM250
AH68-02665J-00
AH68-02665J
02665J-00-WAM250-QG-ZA.indd 1 2013-09-06 오전 10:28:46