Samsung SCH-R460WRACRI - Manual (Page 100)

97
• Send Picture — Lets you launch the Create Pic Msg screen. (See
“Send Picture Messages in Standby Mode” on page 49 for more
information.)
• Lookup — Lets you look up and display contact information for any
name stored in your Contacts list by saying the name. (See “Finding a
Contacts Entry” on page 38 for more information.)
• Go to — Lets you access the Voice Memo, Calendar, and Contacts List
features of your phone. (See “Voice Memo” on page 81, “Calendar”
on page 85, and “Your Contacts List” on page 35 for more
information.)
• Check — Lets you check your phone's status (that is, network
coverage, signal strength, and battery in the same report), network
coverage, signal strength, battery, and phone number.
Note: Speaking clearly, say the command that you want to use. If, after a few
seconds, the device has not recognized a command, it prompts you to
repeat the command. If, after a few more seconds, it still has not
recognized a command, it tells you “Sorry, no match found,” and
cancels voice recognition.
Voice Command Tips:
• Make sure you wait for the beep before speaking.
• Speak clearly at a normal volume, as if you were talking on the phone.
Voice-Activating Your Contacts List
When you first start VoiceSignal, it reads your Contacts list and
voice-activates all the names stored there. When you have add or
change contacts, VoiceSignal automatically reloads and voice-
activates the entire list.
Ending Calls Before Restarting the VoiceSignal Software
When you use VoiceSignal to make a call, you must end that call
before you can use VoiceSignal again.
Voice Settings
Choice Lists
VoiceSignal uses choice lists when it is not confident it has
correctly recognized a name or number. In this case, it can
display a list of up to three possible choices, and prompt you to
confirm the correct one.
You can change the way that VoiceSignal uses choice lists with
name dialing, digit dialing, and contacts. For each feature, you
can choose to always see a choice list (even if there is only one
choice), or never see a choice list (even if there are multiple
choices). If you leave the setting at “Automatic,” VoiceSignal
displays a choice list only when it is not confident it has correctly
recognized the name or number.
To change the way VoiceSignal uses choice lists:
1. From the Voice SVC menu, select Voice Settings ➔
Choice Lists the following options appear in the display: