Samsung LN52C530F1FXZA - Manual (Page 37)

37
English
05
Other Information
Issues solutions and Explanations
Others
The cable/set top box remote control
does not turn the TV on or off, or adjust
the volume. Program the Cable/Sat remote control to operate the TV. Refer to the Cable/Sat user manual •
for SAMSUNG TV code.
A “Mode not supported” message
appears. Check the supported resolution of the TV and adjust the external device’s output resolution •
accordingly. Refer to resolution settings in this manual.
Caption on TV menu is greyed out. Caption • can not be selected in the TV menu when connected via HDMI or Component.
Caption • must be activated on the external device.
There is a plastic smell from the TV. This smell is normal and will dissipate over time. •
TV signal Information is unavailable in
the self Diagnosis Test menu. This function is only available with digital channels from an Antenna / RF/Coax connection. •
(P. 21)
TV is tilted to the right or left side. Remove the stand base from the TV and reassemble. •
Channel menu is grey out (unavailable). Channel • menu is only available when the TV source is selected (Antenna or Cable).
Your settings are lost after 30 minutes
or every time the TV is turned off. If TV is in the • store Demo mode, it will reset audio and picture settings every 30 minutes.
Please change from store Demo mode to home Use mode in the Plug & Play procedure.
Press the
sOURCE button to select TV mode, go to MEnU → setup → Plug & Play →
EnTER E.
You have intermittent loss of audio or
video. Check the cable connections and reconnect them. •
Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the •
cables are flexible enough for long term use. mounting the TV to the wall, we recommend using
cables with 90 degree connectors.
The PIP menu is not available. PIP functionality is only available when you are using a HDMI, PC or components source. •
You see small particles when you look
closely at the edge of the frame of the
TV. This is part of the product’s design and is not a defect. •
POP (TV’s internal banner ad) appears
on the screen. Select • home Use under Plug & Play mode.
For details, refer to Plug & Play (Initial Setup). (P. 7)
This TFT LCD panel uses a panel consisting of sub pixels which require sophisticated technology to produce. However,
✎
there may be a few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
storage and Maintenance ¦
Do not spray water or a cleaning agent directly onto the
product. Any liquid that goes into the product may cause a
failure, fire, or electric shock.
Clean the product with a soft cloth dapped in a small
amount of water.
BN68-02540C-Eng.indb 37 2010-09-01 �� 9:35:57