Important safety instructions, Safety information, Class 1 laser product – Samsung HT-H4500-ZA User Manual

Page 3

Advertising
background image

3

- English

Safety Information

!

Do not allow children to hang on the product.

!

Store the accessories (battery, etc.) in a location safely
out of the reach of children.

!

Do not install the product in an unstable location such
as a shaky self, a slanted floor, or a location exposed
to vibration.

!

Do not drop or strike the product. If the product is
damaged, disconnect the power cord and contact a
service center.

!

To clean this apparatus, unplug the power cord from
the wall outlet and wipe the product using a soft,
dry cloth. Do not use any chemicals such as wax,
benzene, alcohol, thinners, insecticide, air fresheners,
lubricants, or detergent. These chemicals can damage
the appearance of the product or erase the printing
on the product.

!

Do not expose this apparatus to dripping or splashing.
Do not put objects filled with liquids, such as vases on
the apparatus.

!

Do not dispose of batteries in a fire.

!

Do not plug multiple electric devices into the same
wall socket. Overloading a socket can cause it to
overheat, resulting in a fire.

!

There is danger of an explosion if you replace the
batteries used in the remote with the wrong type of
battery. Replace only with the same or equivalent
type.

WARNING :

!

TO PREVENT THE SPREAD OF FIRE,
KEEP CANDLES AND OTHER ITEMS
WITH OPEN FLAMES AWAY FROM THIS
PRODUCT AT ALL TIMES.

!

This product contains chemicals known to the State of
California to cause cancer and reproductive toxicity.

!

To reduce the risk of fire or electric shock, do not
expose this appliance to rain or moisture.

FCC NOTES (for U.S.A)

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on.
If interference is present, the user is encouraged to try to
correct the interference by one or more of the following
measures:

!

Reorient or relocate the receiving antenna.

!

Increase the separation between the equipment and
receiver.

!

Connect this equipment to an outlet on a circuit that
the receiver is not connected to.

!

Consult the dealer or an experienced radio/TV
technician for help.

This class B digital product meets all requirements

of the Canadian Interference - Causing Equipment

Regulations.

CLASS 1 LASER pROdUCT

This product is classified as a CLASS 1 LASER product.
Use of controls, adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
Complies with 21CFR 1040.10 except for deviations
pursuant to Laser Notice No. 50, dated June 24, 2007.

dANGER :

!

VISIBLE AND INVISIBLE LASER RADIATION WHEN
OPEN. AVOID DIRECT EXPOSURE TO BEAM.
(FDA 21 CFR)

CAUTION :

!

CLASS 3B VISIBLE AND INVISIBLE LASER RADIATION
WHEN OPEN. AVOID EXPOSURE TO THE BEAM (IEC
60825-1)

!

THIS PRODUCT UTILIZES A LASER. USE OF
CONTROLS OR ADJUSTMENTS OR PERFORMANCE
OF PROCEDURES OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE. DO NOT OPEN THE COVER. DO NOT
REPAIR THE PRODUCT YOURSELF. REFER SERVICING
TO QUALIFIED PERSONNEL.

CLASS 1

LASER PRODUCT

KLASSE 1

LASER PRODUKT

LUOKAN 1 LASER LAITE

KLASS 1

LASER APPARAT

PRODUCTO LÁSER CLASE 1

Important Safety Instructions

Read these operating instructions carefully before using
the unit. Follow all the safety instructions listed below.
Keep these operating instructions handy for future
reference.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in

accordance with the manufacturer’s instructions.

Advertising