Samsung HCR4245WX-XAA - Manual (Page 18)

English - 18
I
N S TA L L AT I O N
Connecting a VCR
These instructions assume that you have already connected your TV to an antenna or a
cable TV system (according to the instructions on pages 14~17). Skip step 1 if you have not
yet connected to an antenna or a cable system.
1
Connect a coaxial cable between the “ANT 1 IN (Air)”
(or “ANT 2 IN (Cable)”) terminal on the TV and the
antenna out terminal on the VCR.
A coaxial cable is usually included with a VCR. (If
not, check your local electronics store).
2
Connect a set of audio cables between the “AV IN 1
(L, R)” (or “AV IN 2 (L, R)”) jacks on the TV and AUDIO
OUT jacks on the VCR.
If you have a mono VCR, connect L(mono) to VCR
audio out using only one audio cable.
3
Connect a video cable between the “AV IN 1 (VIDEO)”
(or “AV IN 2 (VIDEO)”) jack on the TV and the VIDEO
OUT jack on the VCR.
Follow the instructions in “Viewing a VCR or
Camcorder Tape” to view your VCR tape.
• Also, you can connect to “AV 3” on the side panel of TV.
TV Rear Panel
From Cable
Coaxial Cable
From Antenna
Video
Cable
Audio Cable
VCR Rear Panel
1
2
3
BP68-00334B-00Eng 2005/02/15 04:38 PM Page 18