Samsung HPP4271X-XAA - Manual (Page 38)

38
Setting Up Your Remote Control
This PDP's remote control can operate almost any VCR, cable box or DVD. After it has been set up
properly, your remote control can operate in four different modes :TV , VCR, CATV(Cable box), DVD,
or STB. Pressing the corresponding button on the remote control allows you to switch between these
modes, and control whichever piece of equipment you choose.
Notes : ● The remote control may not be compatible with all DVD Players, VCRs, Cable boxes.
● The remote control can only operate STB made by Samsung.
Setting Up the Remote to Operate Your VCR, CATV(Cable box), or DVD player
1 Turn off your VCR (or CATV(Cable box),
DVD player).
2 Press the MODE button. The Mode is changed
whenever MODE button is pressed.
3 Press the SET button on your TV's remote control.
4 Using the number buttons on your remote control,
enter three digits of the VCR (or Cable box, DVD
player) code listed on page 39 of this manual for
your brand of VCR (or CATV(Cable box), DVD).
Make sure you enter three digits of the code,
even if the first digit is a "0".
(If more than one code is listed, try the first one.)
5 Press the POWER button on the remote control.
Your VCR (or CATV(Cable box), DVD) should turn
on if your remote is set up correctly. If your VCR
(or CATV(Cable box), DVD) does not turn on after
setup, repeat steps 2, 3, and 4, but try one of the
other codes listed for your brand of VCR (or
CATV(Cable box), DVD).
If no other codes are listed, try each code, 000
through 089 (or Cable box: 000 through 077,
DVD player: 000 through 008).
Notes
• When your remote control is in “VCR” mode, the VCR control buttons (STOP, REW, PLAY/PAUSE, FF)
still operate your VCR.
When your remote control is in “CATV” or “DVD” mode, the VCR control buttons (STOP, REW,
PLAY/PAUSE, FF) still operate your VCR.
• You do not need to program the remote for Samsung STBs as the codes are pre-programmed.
BN68-00757A-X2Eng_028~069 7/26/04 4:51 PM Page 38