AGFA SNAPSCAN E42 - Manual (Page 21)

Chapter 2: Installing the Scanner for PC 21
Connecting the Scanner to Your PC
Caution: For your safety, use the adapter that comes with this product. Do not use any substitute.
Misuse of the power adapter can cause serious damage to the product and a safety hazard while
using it.
# Note: Check if the AC Adapter complies with your local power supply.
# Note: Make sure the scanner is unlocked (see Unlocking the Scanner ) before connecting it to
the electric outlet.
1 Connect the Transparancy option as shown in the figure below (e52 only).
2 Connect the plug of the AC adapter to your scanner.
3 Plug the adapter cable in the wall outlet.
4 Connect one end of your USB cable to the USB port on your scanner. Make sure you connect
the correct plug as shown in the figure below.
5 Connect the other end of your USB cable to a USB port on your computer. Make sure you
connect it to the correct port as shown in the figure below. A USB port is labeled with the USB
icon .
Windows will now detect the scanner and will install the necessary files for the scanner
hardware driver.