AMX Modero CV7 User Manual
Nxd/t-cv7
Advertising
Table of contents
Document Outline
- NXD/T-CV77" Modero® Touch Panel
- Introduction
- CV7 Touch Panel Accessories
- Overview
- NXA-AVB/ETHERNET Breakout Box (FG2254-10)
- Modero Table Top Cable (CA2250-50)
- NXA-WC80211B/CF 802.11b Wireless Card (FG2255-03)
- NXA-WC80211GCF 802.11g Wireless Card (FG2255-07)
- NXA-CFSP Compact Flash (FG2116-3x)
- Before Upgrading the Wireless Card - Read This...
- Installation and Upgrade of the Internal NXT Components
- Installation and Upgrade of the Internal NXD Components
- NXT-BP Power Pack (FG2255-10)
- NXA-BASE/1 Battery Base Kit (FG2255-05K)
- NXT-CHG Battery Charger Kit (FG2255-50K)
- Installation
- Overview
- Unpacking the Panel
- Installing the Internal Components
- Installing the No-Button Trim Ring
- Installing the Button Trim Ring
- Pre-Wall Installation of the Rough-In Box
- Installation of an NXD Touch Panel
- Wiring Guidelines for the CV7 Panels
- Audio/Video Port: Connections and Wiring
- Ethernet/RJ-45 Port: Connections and Wiring
- USB Port: Connecting and Using Input Devices
- Panel Calibration
- Configuring Communication
- Overview
- Modero Setup and System Connection
- Configuring and Using USB with a Virtual Master
- Step 1: Setup the Panel and PC for USB Communication
- Step 2: Confirm the Installation of the USB Driver on the PC
- Step 3: Confirm and View the current AMX USB device connections
- Step 4: Use the USB to Configure a Virtual Master (using NetLinx Studio)
- Step 5: Confirm and View the current AMX USB device connections
- Wireless Settings Page - Wireless Access Overview
- Configuring a Wireless Connection
- Step 1: Configure the Panel’s Wireless IP Settings
- Step 2: Configure the Card’s Wireless Security Settings
- Configuring a Wired Ethernet Connection
- Step1: Configure the Panel’s Wired IP Settings
- Step 2: Choose a Master Connection Mode Setting
- Step 3: Configure an Ethernet Connection Type
- Using G4 Web Control® to Interact with a G4 Panel
- Using your NetLinx Master to control the G4 panel
- Upgrading Modero Firmware
- Firmware Pages and Descriptions
- Setup Navigation Buttons
- Setup Page
- Protected Setup Navigation Buttons
- Protected Setup Page
- G4 Web Control Page
- Sensor Setup
- Making the most of the Automated Brightness Control feature (DIM Mode)
- Password Setup Page
- Calibration Page
- Wireless Settings Page
- Wireless Settings Page - Security Options - Overview
- Wireless Settings Page - Security Options - Open (Clear Text)
- Wireless Settings Page - Security Options - Static WEP
- Wireless Settings Page - Security Options - WPA-PSK
- Wireless Settings Page - Security Options - EAP-LEAP
- Wireless Settings Page - Security Options - EAP-FAST
- EAP Security’s Using Server Certificates - Overview
- Programming
- Appendix A
- Appendix B - Wireless Technology
- Troubleshooting