Samsung LE32S74BD - Manual (Page 8)

English-6
Selects a target device to be
controlled by the Samsung remote control
(TV, DVD, STB, CABLE, VCR)
(Refer to page 3~35)
Television Standby button
Number buttons for direct
channel access
One/Two-digit channel selection
It display "Channel Manager"
on the screen.
Selects the TV and DTV mode directly
VCR/DVD Functions
Rewind, Stop, Play/Pause,
Fast/Forward
Volume increase
Volume decrease
Temporary sound switch-off
Menu display and
change confirmation
Electronic Program Guide (EPG) display
Picture-In-Picture On / Off
Sound effect selection
Previous channel / This key is used
in the MHP application and to change
the previous channel.
This key is also used to back to the
previous page in D.MENU.
Set: Adjusts 5 separate devices - TV, DVD,
STB, CABLE, or VCR.
reSet: When your remote does not work,
change the batteries and press the
“RESET” button for 2-3 seconds
before use.
Available source selection
Previous channel
DTV menu display
Toggle between the TV
and Radio channel
P : Next channel
P : Previous channel
Exit the OSD
Control the cursor in the menu
Use to see information on the
current broadcast
Digital subtitle display
(Not available in Spain)
This button is the hard key for
accessing MHP Application List
Picture freeze
Select the soundtrack/videotrack
list for the current service
teletext Functions
Exit from the teletext display
Teletext index
Teletext hold
Select the teletext mode
Teletext size selection
Teletext mode selection (LIST/FLOF)
Teletext sub page
P : Teletext next page
P : Teletext previous page
Teletext cancel
Teletext reveal
Alternately select Teletext, Double, or Mix.
Fastext topic selection
Teletext store
The performance of the remote control may be affected by bright light.
This is a special remote control for the visually impaired, and has Braille points on the
Power, Channel and Volume buttons.
Viewing the remote Control
1. Lift the cover at the back of the remote control upward as shown in the figure.
2. Install two AAA size batteries.
Make sure to match the "+" and "–" ends of the batteries with the diagram inside the compartment.
3. Replace the cover.
Remove the batteries and store them in a cool, dry place if you won’t be using the remote control for a long time.
The remote control can be used up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries last for about one year.)
if the remote control doesn’t work, check the following:
. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
installing Batteries in the remote Control
BN68-01007M-00Eng.indd 6 2006-07-05 �� 9:55:55