Mounting the trim ring, Mmd11 a – Movies2Go MMD11A User Manual
Page 7
7
MOUNTING THE TRIM RING
Roof
Roof Support
Headliner
Mounting Bracket
Self-drilling Screws
Trim Ring
Video Unit
M5 Screw
MMD11 A
1)
Make the connections to the vehicle for the 12 pin wiring harness.
2)
Connect power harness to vehicle’s electrical system by tapping into an accessory hot
line and a good ground.
3)
Connect the 12 pin harness to the mating connector on the Video Monitor.
4)
Verify all functions of the System before final mounting of the finished assembly.
A/V Source Definitions:
1. DVD – Built in DVD
2. AV1 – Supplied 9 Pin to 3 RCA Jack Pigtail is used for VIDEO 1 input.
3. AUX – AUX
*NOTE: If the optional relay box P/N SIRSWB is installed, it recommended that the
antenna for the wireless FM Modulator be unplugged. See MMD11 A Wiring
Diagram (Figure A) for antenna location.
**NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM
Modulator to exceed FCC limits for wireless transmission. When installing the
unit position the antenna for best reception.