Hubbardton Forge 124555 - Manual (Page 2)

Assembly & Installation Instructions
A115
For Compass Semi-Flush 12-4555 Page 2 of 2
Hand-Forged, Vermont-Made Lighting and Accessorie
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 19841 Rev B
Install the Threaded Rods (Figure 2)
Component Parts
F Canopy
G Canopy
Ring
I Knurl Ball (4)
J Threaded Rod (4)
1. Slip bent end of threaded rod (J) through holes in canopy (F).
2. Thread knurl ball (I) onto threaded rod (J) until snug against inside of
canopy (F).
3. Slide fixture canopy (F) against ceiling, and secure with canopy ring (G).
To Install Glass Frame and Glass (Figure 3)
Component Parts
I Knurl Ball (4)
J Threaded Rod (4)
K Glass
Frame
L Tab
M Glass
1. Slip tabs on glass frame (K) onto three threaded rods (J)
and attach with knurl ball (I).
2. Slip glass (M) into glass frame (K) so it rests below the
three tabs.
3. Slip tab (L) onto last threaded rod (J) and slide onto glass
frame (K).
4. Thread knurl ball (I) onto threaded rod (J).
5. Install light bulbs (not provided).
6. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)
(Figure 3)
(Figure 2)