Hubbardton Forge 844007 User Manual

Installation instructions

Advertising
background image

Installation Instructions

F16

For Rook Paper Towel Holder 84-4007

Hand-Forged,

Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24321

To Install

Component Parts

A Mounting Arm (2)
B Set Screw (2)
C Wall Mount Plate (2)
D Screws

(4)

E Wall Anchors (4)
F Removable

Bar

G Fixed

Bar

H Magnet

1. Remove wall mount plate (C) from the mounting arm (A) by

loosening set screw (B) and sliding wall mount plate (C) from
mounting arm (A). Do this for both arms (Figure 1).

2. Hold first wall mount plate (C) in location it is to be mounted.

With a pencil, mark the location of the mounting holes in the wall
mount plate (C) on the wall behind.

3. Measure 12 1/4" from the marked holes for the location of the

second wall mount plate (C).

4. Put the wall mount plate down and drill 1/4" holes in the

locations marked on the wall if wall anchors (E) are to
be used.

If directly attaching to a solid support the

drilled hole is not needed.

For holes using anchors,

place the tapered end of the anchors (E) into the holes
and gently tap them flush to the wall using a light weight
hammer.

5. Install screws (D) through wall mount plates (C) and

into each anchor (E).

If anchors are not needed the

screws (D) can be installed directly to the wall.

6. Tighten set screw (B) in both arms.
7. Remove tape from end of removable bar (F) and discard.
8. Slip removable bar (F) through mounting arm (A) with

magnet pointing towards second mounting arm (A) with
fixed bar (G).

9. Once past first arm slip paper towel roll onto removable

bar (F) and slip bar into second mounting arm until
magnet (H) is touching fixed bar (G).


If you need further assistance, or find that you are missing any
parts, please contact the dealer from which you purchased this
product. We hope you enjoy your fixture!

*

Hubbardton Forge will not be liable for injury or damage

caused by improper installation or use of this fixture.

CAUTION: FAILURE TO INSTALL THIS PRODUCT PROPERLY MAY RESULT IN PERSONAL INJURY
OR PROPERTY DAMAGE. We recommend installation by a qualified individual trained in the building trade.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*

(Figure 1)

(Figure 3)

(Figure 2)

Advertising