Alpine CDA-9853 - Manual (Page 26)

25
-EN
Setting Amplifier Link
When an Amplifier Link compatible amplifier (MRD-M1005 or
MRD-M605, etc.) is connected, the amplifier settings are adjustable
from the head unit. A maximum of 8 external amplifiers can be
adjusted.
1
Press and hold MENU for at least 2 seconds.
2
Select the Amplifier Link (A-LINK) mode by sliding
your finger on the GlideTouch bar to the left or
right. Press the GlideTouch bar under the
Amplifier Link (A-LINK) mode.
3
Select the AMP-ID (AMP-1 to AMP-8) to be adjusted
by sliding your finger on the GlideTouch bar to
the left or right. Press the GlideTouch bar under
the desired AMP-ID.
The input level mode to be adjusted is activated.
If a Mono Amplifier is Connected
4
Adjust the input level by sliding your finger on the
GlideTouch bar to the left or right. Press the
GlideTouch bar under the desired level.
If a 4ch Amplifier is Connected
4
Adjust the input level of CH 1/2 by sliding your
finger on the GlideTouch bar to the left or right.
Press the GlideTouch bar under the desired level.
5
Adjust the input level of CH 3/4 by sliding your
finger on the GlideTouch bar to the left or right.
Press the GlideTouch bar under the desired level.
6
When adjustment has been completed, press and
hold MENU for at least 2 seconds to return to
normal mode.
• For details of each of the settings, refer to the Owner's Manual of
the external amplifier.
• If amplifier settings are made on the unit, do not then change the
setting with the amplifier buttons as the amplifier display may not
match the operations of the unit.
• “No Link” is displayed if the amplifier is removed or its power
cannot be turned on, etc.
• If multiple amplifiers are connected to this unit, set a different ID
on each amplifier. Otherwise the display may flicker.
• External amplifier information display can be changed by pressing
TITLE while adjusting the input level.
• If the GlideTouch bar is pressed and held while adjusting the input
level, the amplifier link mode can be switched between lock and
unlock.
• If MENU is pressed while adjusting or setting the itmes in the
MENU mode, the unit will return to the previous selection secreen.
• By pressing the GlideTouch bar under RETURN in the MENU
mode, the unit will return to the normal mode.
• If no peration is performed in 60 seconds, the unit will return to the
normal mode.
Displaying the External Amplifier Information
When an Amplifier Link compatible amplifier is connected, the
amplifier's status (voltage, temperature and fan status) can be shown
in the head unit's display.
1
Press TITLE in the Radio or CD mode to switch
the display of the external amplifier information.
• For switching the display, refer to the section “Displaying the Title/
Text” (page 22).
• For changing the XM display, refer to the section “Changing the
Display” (page 32).
• For changing the iPod display, refer to the section “Displaying the
Text” (page 36).
CDA-9855
CDA-9853
• To switch the display between Celsius and Fahrenheit, refer to
page 30.
Voltage Display
VOLTAGE:10.1V
75.0˚F
Temperature
Display
Temperature Display
42.0 °C
12.4V HIGH
Fan Status
Display
Voltage Display
The temperature display and
the fan status display are
alternately displayed.
Fan Status
Display Voltage Display
VOLTAGE:10.1V
HIGH