Electronically controlled cameras – Nikon S70 User Manual
Page 180
168
Troubleshooting
Tech
nic
a
l No
tes
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Date imprint not available
• Camera clock has not been set.
• Another function that does not support date
imprint is enabled.
Date not imprinted on pictures
even when Date imprint is
enabled
Date is not imprinted in the following situations:
• Selected shooting mode does not support
date imprint
• Another function that does not support date
imprint is enabled
• Recording movies
Camera settings reset
Backup battery is exhausted; all settings were
restored to their default values.
Monitor turns off, and the
power-on lamp blinks green
rapidly.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
Battery inserted into the
camera is not charged when
the camera is connected to a
computer.
• The battery is not charged when the camera
is turned off.
• Charging stops if the computer enters sleep
mode while the battery is charging. The
camera may be turned off.
• Depending upon computer specifications,
settings, and status, it may be impossible to
charge the battery inserted into the camera
via computer connection.
Problem
Cause/Solution
A