Nikon SB-910 - Manual (Page 78)

D–17
D
Wireless Multiple Flash-unit Photography
Remote Flash Units
Remote flash unit setting
The standby function of the SB-910, SB-900, SB-800, SB-700, SB-600 and •
SB-R200 is canceled when remote mode is set. Make sure that there is sufficient
battery power.
Set the zoom head position of the remote flash units wider than the angle of
•
view, so that the subject will receive sufficient illumination even when the angle
of the flash head is off axis from the subject. When the flash-to-subject distance
is very short, set the zoom head position wide enough to achieve sufficient light.
Setting up the remote flash units
In most cases, position the remote flash units closer to the subject than the •
camera, so that light from the master flash unit can reach the light sensor
window for wireless remote flash of the remote flash units. This is particularly
important when holding a remote flash unit in the hand.