Call intercept, Temporarily turn off the message alert tone, Answering system overview – AT&T DECT 6.0 EL52201 User Manual

Page 51

Advertising
background image

46

Answering system

Answering system overview

If call screening is on and you want to adjust the playback volume to a
comfortable level (1-8) while it is recording messages, press

/ /-vOLumE+

on the telephone base. This volume setting is shared with message playback,
so when you play messages at volume 1, they play at a very low volume. If
you turn up the volume for playback, the call screening for the next incoming
message plays at the same volume level.
If call screening is on and you want to silence the telephone base while it is
recording messages, press

/

pLAy

/sTOp on the telephone base. The call

screening will be on for the next incoming call.
Call screening at the handset:
If the answering system is turned on, when there is an incoming call and it is
answered by the answering system, the handset screen shows “TO SCREEN
CALL, PRESS [SELECT].”
By pressing

mENu

/sELECT, you can screen the call at

the handset.

Call intercept
While call screening, you can stop it manually and speak to the caller.

If the call is screened at the base, press

pHONE/

FLAsH

or

/spEAKEr on the handset to

stop recording and speak to the caller.
If the call is screened at the handset, press

pHONE/

FLAsH

on the handset to stop recording

and speak to the caller. Then you can press

/spEAKEr to switch between the speakerphone and the handset.

Temporarily turn off the message alert tone
To temporarily silence the message alert tone:

When the telephone base is in idle mode, press any
telephone base key (except

/HANDsET LOCATOr).

The message alert tone is activated again with the next
incoming message.

notes:

When the telephone base is in idle mode, if you press

x/DELETE to temporarily silence the

message alert tone, there is a voice prompt directing you to press

x/DELETE again to delete

all old messages (see

Delete all old messages on page 49). If you are not going to delete all

old messages, wait at least 5 seconds to allow the telephone base to return to idle mode.
To turn off the message alert tone, see

message alert tone on page 42.

Advertising
This manual is related to the following products: