AT&T DECT 6.0 EL52201 - Manual (Page 63)

58
Appendix
Troubleshooting
If you have difficulty with your telephone, please try the suggestions below.
For customer service, or to purchase accessories or replacement parts, visit
our website at
www.telephones.att.com
, or call
1 (866) 288-4268
.
When you call customer service, you will need the serial number or model
number found on the bottom of the telephone base.
my telephone doesn’t work at all.
Make sure the power cord is securely plugged in.
Make sure that the battery connector is securely plugged into the
cordless handset.
Make sure the telephone line cord is securely and firmly plugged into the
telephone base and the telephone wall jack.
Charge the battery in the cordless handset for at least 10 hours. For
optimum daily performance, return the cordless handset to the telephone
base or charger when not in use.
If the battery is depleted, it may take approximately 30 minutes to charge
the handset before it shows
LOW BATTEry, refer to Battery charging on
page 6 for details.
Reset the telephone base. Unplug the electrical power. Wait for
approximately 15 seconds, then plug it back in. Allow up to one minute for
the cordless handset and telephone base to reset.
You may need to purchase a new battery. Please refer to
Battery installation
on page 5.
I cannot get a dial tone.
First try all of the suggestions above.
Move the cordless handset closer to the telephone base. You might have
moved out of range.
If the previous suggestions don’t work, disconnect the telephone base from
the telephone wall jack and connect to a different telephone. If there is no
dial tone on that handset either, the problem is in your wiring or telephone
service. Contact your telephone service provider (charges may apply).
Your telephone line cord might be defective. Try installing a new telephone
line cord.
I cannot dial out.
First try all the suggestions in the item I cannot get a dial tone above.
•
•
•
•
•
•
•
•
•
•
•
•