HID DTC1000/4000 User Guide - Manual (Page 30)

© 2012 HID Global Corporation All rights reserved
DTC1000/DTC1000M/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.5)
30
Driver Installation Instructions
 Select “Install the Printer Driver” to start the Driver installation.

Select the Fargo Workbench Utility Program to install the Diagnostic program.

Select the Swift ID™ to install the Swift ID (Embedded Badging Application software) follow the
Installaware Wizard.

All versions of Windows require Administrator rights.

From the Printer & Faxes folder, open the Printing Preferences to setup the Driver after it has been
installed.

Printing Preferences need to be setup after the Driver has been installed. Each TAB is shown below.

Use the drop down arrows to select the correct options for each printing preference.

Enable Swift ID over a USB connection: This item will be checked if the Printer is setup to utilize
Swift ID via a USB connection.
o When this box is checked the Ethernet connection (if applicable) on the Printer will not be
operational.
o If this selection is not accessible, this is because the HID EEM Driver that Swift ID uses to
connect via a USB connection has not been installed.
o This Driver can be found on the installation CD or it can be down loaded from the HID
Global support page.
o The easiest method for enabling Swift ID is to un-install the Printer and its components and
go through the installation procedure and select that you would like to use the Swift ID
application.