Additional printer specific tools – HID DTC1000/4000 User Guide User Manual
Page 99
© 2012 HID Global Corporation
All rights reserved
DTC1000/DTC1000M/DTC4000 Card Printer/Encoder User Guide (L001398, Revision 1.5)
99
Additional Printer Specific Tools
Label
Description
INFO
Printer Type
Firmware Version
IP Address
Flipper
Lamination
Magnetics
E-Card
Password
Card count
TEST
PRINTS
Color Photo:
Select this to print a color card to test communication and integrity.
Alignment:
Select this to print a card used to align the print image on the card.
Settings:
Select this to print a card with the Advanced settings.
Resin:
Select this to print a RESIN test card.
Rewritable:
Select this to ERASE the Rewritable card.
Magnetic:
Select this to test Magnetic encoding. (Hi-Co only)
Lamination:
Select this to laminate a test card.
Hopper
Select
Ability to select which hopper to feed cards from. Applies to Dual
Hopper Printers.
Toolbox
Clean Printer:
Select this to run the clean printer routine.
Clean Laminator:
Select this to run the clean laminator routine.
Calibrate Mag:
Select this to calibrate the Magnetic Sensor