Approach Tech DVR-3016 - Manual (Page 12)

10
2.3 ALARM In/Out
The pin assignment of the female DB-25 alarm I/O connector is listed as follows.
alarm I/O
1 2 3 4 5 6 7 8 9 10 11 12 13
14 15 16 17 18 19 20 21 22 23 24 25
Pin# Pin Assignment Pin# Pin Assignment
1 GROUND 14 RESERVED
2 DISK FULL (OUTPUT) 15 ALARM1 OUT (OUTPUT)
3 ALARM2 OUT (OUTPUT) 16 ALARM3 OUT (OUTPUT)
4 RECORD IN (INPUT) 17 ALARM RESET (INPUT)
5 ALARM1 IN (INPUT) 18 ALARM2 IN (INPUT)
6 ALARM3 IN (INPUT) 19 ALARM4IN (INPUT)
7 ALARM5 IN (INPUT) 20 ALARM6 IN (INPUT)
8 ALARM7 IN (INPUT) 21 ALARM8 IN (INPUT)
9 ALARM9 IN (INPUT) 22 ALARM10 IN (INPUT)
10 ALARM11 IN (INPUT) 23 ALARM12 IN (INPUT)
11 ALARM13 IN (INPUT) 24 ALARM14 IN (INPUT)
12 ALARM15 IN (INPUT) 25 ALARM16 IN (INPUT)
13 NO CONNECTION
NOTE: THIS FIGURE IS SEEN FROM THE REAR VIEW
GROUND: Ground Contact.
DISK FULL (OUTPUT): This is a disk full output trigger. Connect this to external devices
such as buzzers or lights. (
5V
0V(Active)
)
ALARM OUT (OUTPUT): This is an alarm output trigger. Connect this to external devices
such as buzzers or lights. (
5V
0V(Active)
)
RECORD IN (INPUT): This pin connects to a record trigger device for starting a record.
(
5V
0V(Active)
)
ALARM RESET (INPUT): This pin connects to an alarm-clear device for clearing an alarm.
(
5V
0V(Active)
)
ALARM IN (INPUT): This is an alarm input (for each channel) that can be programmed in
the menu system to Normally Open or Normally Closed. (
5V
0V(Active)
)