Avery MONARCH 7411 - Manual

Monarch
, MonarchNet2, 7411 are trademarks of Avery Dennison Retail Information Services LLC. Avery
Dennison
 is a trademark of Avery Dennison Corp.
Microsoft, Windows, and NT are trademarks of Microsoft Corporation.
Novell and NetWare are trademarks of Novell, Inc.
HP Jet Admin and HP Web Jet Admin are trademarks of Hewlett-Packard, Inc.
Other products are trademarks or registered trademarks of their respective
companies and are hereby acknowledged.
TC9906MN2SG Rev. AA 8/10 Avery Dennison Corp. All rights reserved.
E T H E R N E T S E T U P G U I D E
The Monarch
 7411 wireless Ethernet Print Server lets you communicate
with a Monarch
 9906 printer on a 10baseT or 100baseTX wired Ethernet
network or on an 802.11b or 802.11g wireless network. The print server
operates in Ad-Hoc (peer-to-peer) mode or infrastructure (access point)
wireless mode. You can also remotely manage and download print batches,
formats, printer configurations, and fonts. Refer to the MonarchNet2™
Operating Instructions found on our Web site (
www.monarch.com ).
The print server supports multiple network protocols for users with
Telnet/FTP, Microsoft
 Windows 98, 2000, NT, XP, and Vista™, TCP/IP
(including LPR/LPD, Bootp, DHCP, and HP JetDirect
), Novell NetWare
and SNMP. All protocols are simultaneously active.
Note: When turning on the printer or after sending a ^PR (printer reset)
immediate command, wait at least 30 seconds before sending data
to the print server. Any data sent to the print server before the 30-
second interval may be lost.
Information in this document supersedes information in previous versions.
Check our Web site for the latest documentation and release information.
C o n f i g u r i n g t h e P r i n t S e r v e r
1. Start your Web browser.
2. Type in your printer’s IP address (for example, 192.0.0.192) on your
computer. If you are not sure of your printer’s IP address, print a
configuration label. See, “Printing a Configuration Label,” for more
information.
The printer’s display shows the network symbol (wired) or the
antenna symbol (wireless) when the printer is connected and ready
to receive data.