Sony KDL-46V25L1 - Manual (Page 8)

8
(GB)
SU-WL51
2-652-380-11(1)
The procedure differs depending on
the TV or monitor. Apply the
procedure appropriate for the TV or
monitor you are installing.
KDL-40S2000/KDL-40S2010................... A
KLV-40U100M .......................................... B
If you intend to install a TV or monitor that is not specified
on above, be sure to refer to the leaflet “Installing the Wall-
Mount Bracket” supplied with your TV or monitor.
Step 4:
Preparing for the
installation of the
TV or monitor
1
Remove the screws from the rear
side of the TV or monitor.
A
B
Remove the eight screws from these
eight holes in the rear side of the
monitor.
2
Detach the Table-Top Stand from
the TV or monitor.
A
B
3
Attach the supplied four hooks
on the rear side of the TV or
monitor.
Place the TV or monitor with its screen facing down on
a stable cloth-covered work surface.
Attach the supplied four hooks with the four supplied
screws (+PSW5 × L16).
Notes
• When using an electric screwdriver, set the torque setting
to approximately 2 N·m {20 Kgf·cm}.
• Be sure not to use any screws other than the supplied ones
(+PSW5 × L16) when attaching the hooks.
Soft cloth
Align the hook with the circle on the
rear side of the TV or monitor.
01GB01COV.book Page 8 Tuesday, December 20, 2005 4:59 PM