Sony STR-DN1050 - Manual (Page 341)

MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
The Control for HDMI function does not work.
Check the HDMI connection.
Make sure [Control for HDMI] is set to [On] in the HDMI Settings menu.
Make sure the connected device supports the Control for HDMI function.
Check the Control for HDMI settings on the connected device. Refer to the operating instructions of the connected
device.
If you unplug the HDMI cable or change the connection, repeat the procedures of “
Preparing for “BRAVIA” Sync .”
When [Control for HDMI] is set to [Off], “BRAVIA” Sync does not work properly, even if the device is connected to the
HDMI IN jack.
The types and number of devices that can be controlled by the “BRAVIA” Sync feature are restricted by the HDMI
CEC standard as follows:
Recording devices (Blu-ray Disc recorders, DVD recorders, etc.): up to 3 devices
Playback devices (Blu-ray Disc players, DVD players, etc.): up to 3 devices
Tuner-related devices: up to 4 devices (the receiver uses one of them for its GUI operations.)
AV receivers (audio systems): up to 1 device
Make sure your TV is connected to the HDMI OUT A jack of the receiver (for STR-DN1050 only).
Make sure the HDMI OUTPUT setting is set to [HDMI A] or [HDMI A + B] (for STR-DN1050 only).
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
Help Guide
330