Sony NV-U83T - Manual (Page 20)

20
Activating the Bluetooth signal
1
In the menu display, touch , then
“Phone.”
2
Select “Bluetooth Signal,” then “ON.”
The signal is activated.
The Bluetooth indicator in the bottom right of
the unit lights up in blue.
Pairing with a cellphone
Pairing is required only the first time you
connect to a cellphone.
To pair this unit to a cellphone, you need to enter
the same passkey* on this unit and on the
cellphone. The passkey can be either your own
selected number or the number determined by
the cellphone.
For details, see the manual of the cellphone.
* Passkey may be called “passcode,” “PIN code,”
“PIN number,” “password,” etc., depending on the
cellphone.
Searching from this unit
The procedure to search for a cellphone from this
unit is explained below.
Check that the cellphone is set to allow for
searching beforehand.
1
In the menu display, touch , then
“Phone.”
2
Select “Add Devices.”
A message asking you to set the cellphone to
detectable appears.
3
Select “Search for Phone.”
After cellphone search is complete, the list of
connectable cellphones appears.
To list cellphones by address, select
“Address.”
To list by name, select “Name.”*
* The address appears instead of the name if
unavailable.
4
Select the cellphone to register.
Pairing starts.
5
Enter the passkey.
Perform the required operation also on the
cellphone.
A message appears stating that the pairing is
complete.
To connect to the cellphone, select “Connect.”
Searching from a cellphone
The procedure to search for this unit from a
cellphone is explained below.
In this case, the name of the unit is registered as
“nav-u,” which can be changed in the phone
setting (page 27).
1
Start searching for this unit from the
cellphone.
For details, see the manual of the cellphone.
After you perform the required operation on
the cellphone, the passkey input display
appears on this unit.
2
Enter the passkey.
A message appears stating that the pairing is
complete.
Connecting to a cellphone
Once the Bluetooth signal is activated, the unit
searches for the last connected cellphone, and
connection is made automatically if possible.
In this chapter, instructions on how to connect
manually to paired cellphones are introduced.
Before starting, be sure to activate the Bluetooth
signal both on this unit and the cellphone.
1
In the menu display, touch ,
“Phone,” then “My Devices.”
The list of paired cellphones appears.
2
Select the cellphone to connect.
The confirmation display appears.
3
Select “OK.”
The unit is connected to the selected
cellphone.
The currently connected cellphone is
indicated by in the paired cellphone list.
To disconnect
In step 2 above, select the cellphone to
disconnect (one that is currently connected)
c
“OK.”