Sony RM-VL700S - Manual (Page 29)

29
2
Press and hold for over 3
seconds the desired
Component Select button to
which you want to copy a
setting from another
component.
While holding down this
button, the other Component
Select buttons flash. Then,
when you press the
Component Select button
which holds the setting you
want to copy, all Component
Select buttons light up. When
copying is complete, any
Component Select buttons
other than the two buttons
pressed, turn off.
To cancel setting, press SET.
To return the setting of the
Component Select button to the
original component setting
Clear the “learned” function (page
21) and perform the original
component setting following the
procedure on page 27.
Tip
Small data will be processed soon.
Copying the settings of a
Component Select button
to another button
You can copy the entire settings of
a Component Select button to
another Component Select button.
The settings of the component
code (page 8) and the “learned”
function (page 15) are copied to a
new button.
Note
You cannot copy the settings to a
Component Select button on which any
“learned” function (page 15) has been
programmed.
Example: To copy the settings of
the DVD button to the TV button
1
Press SET.
All Component Select buttons
flash.
for over 3 seconds