Sony DCR-HC1000 - Manual (Page 14)

Getting started 14
7
Slide the POWER switch up to (CHG)
OFF.
The (flash)/CHG (charge) lamp lights up
and charging starts.
After charging the battery
The (flash)/CHG (charge) lamp turns off
when the battery is fully charged. Disconnect
the AC Adaptor from the DC IN jack.
To remove the battery pack
1
Set the POWER switch to (CHG) OFF.
2 Open the battery compartment lid.
3 Unlatch the battery release tab in the
direction of the arrow and remove the
battery pack.
b Note
• If you do not use the battery pack for a long time, use
up the battery pack completely before storing it. See
page 124 about storage of the battery pack.
To check the remaining battery – Battery
Info
You can check the battery’s current charge level
and its current remaining recording time both
during charging or when the power is turned off.
1 Set the POWER switch to (CHG) OFF.
2 Press OPEN and open the LCD panel.
3 Press DISPLAY/BATT INFO.
The battery information appears for about 7
seconds.
Keep the button pressed to view it for about
20 seconds.
A Battery charge level: Displays
approximate remaining amount of
power left in the battery pack.
B Approximate possible recording time
using the LCD panel.
C Approximate possible recording time
using the viewfinder.
/CHG
Flash/charge lamp
POWER switch Battery release tab
Battery pack
POWER switch
DISPLAY/
BATT INFO
OPEN
BATTERY INFO
50% 0% 100%
BATTERY CHARGE LEVEL
REC TIME AVAILABLE
LCD SCREEN
VIEWFINDER
:
:
108 min
121 min