Sony CMT-V10IPN - Manual

CMT-V10iPN (GB) 4-462-380-11 (1)
Owner’s Record
The model and serial numbers are located on the bottom
exterior of the main unit. Record these numbers in the
space provided below. Refer to them whenever you call
upon your Sony dealer regarding this product.
Model No.
Serial No.
WARNING
To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or
moisture.
To reduce the risk of fire or electric shock, do not expose
this apparatus to dripping or splashing, and do not place
objects filled with liquids, such as vases, on the apparatus.
To reduce the risk of fire, do not cover the ventilation
opening of the apparatus with newspapers, tablecloths,
curtains, etc.
Do not place the naked flame sources such as lighted
candles on the apparatus.
Do not install the appliance in a confined space, such as a
bookcase or built-in cabinet.
As the main plug of AC adaptor is used to disconnect
the AC adaptor from the mains, connect it to an easily
accessible AC outlet. Should you notice an abnormality
in it, disconnect it from the AC outlet immediately.
Do not expose batteries or apparatus with battery-
installed to excessive heat such as sunshine, fire or the
like.
The AC adaptor is not disconnected from the mains as
long as it is connected to the AC outlet, even if the main
unit itself has been turned off.
The nameplate is located on the bottom exterior of the
main unit and on the surface of the AC adaptor.
CAUTION
The use of optical instruments with this product will
increase eye hazard.
Notice for the customers in the Canada
This Class B digital apparatus complies with Canadian
ICES-003.
Notice for the customers in the U.S.A.
The dating code is located on the bottom exterior of the
main unit.
Important Safety Instructions
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type
plug has two blades and a third grounding prong.
The wide blade or the third prong are provided for
your safety. If the provided plug does not fit into your
outlet, consult an electrician for replacement of the
obsolete outlet.
10) Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the
manufacturer.
12) Use only with the cart, stand, tripod,
bracket, or table specified by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination to
avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
14) Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
The following FCC statement applies only
to the version of this model manufactured
for sale in the U.S.A. Other versions may
not comply with FCC technical regulations.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and
receiver.
 Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV
technician for help.
CAUTION
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
Note on DualDiscs
A DualDisc is a two sided disc product which mates
DVD recorded material on one side with digital
audio material on the other side. However, since the
audio material side does not conform to the Compact
Disc (CD) standard, playback on this product is not
guaranteed.
Getting Started
Location of Controls
To use the iPod/iPhone
1 Open the dock by pushing the center of the dock.
Dock
2 Place the iPod/iPhone.
Operations
Playing a CD/MP3 disc
1 Select the CD function.
Press CD FUNCTION  on the remote or press
FUNCTION  on the unit repeatedly.
2 Open the CD door.
Press  (Open/Close)  on the unit.
 (Open/Close) 
3 Set a disc.
Push the center part of the disc with two fingers until
the disc snaps into its mounted position.
Set a disc with the
label side facing
forward.
4 Close the CD door.
Press  (Open/Close)  on the unit.
“READING” appears.
5 Start playback.
Press   on the remote or press   on the
unit.
To eject a disc
Press  (Open/Close)  on the unit and remove the
disc by pulling up the edge of the disc while holding one
finger against the spindle.
Notes
The system will automatically close the CD door  if a few minutes
elapse of no operation with the CD door open.
Do not set a disc with non-standard shapes (e.g., heart, square, star).
The disc may fall into the system and cause irreparable damage.
If you press /  with the CD door open, the system will
automatically close the CD door.
Do not use a disc with tape, seals or paste on it as this may cause a
malfunction.
When you eject a disc, handle the disc by its edge. Do not touch the
surface.
Other operations
To Press
Pause playback   (or   on the unit). To
resume play, press the button again.
Stop playback  .
Select a folder on
an MP3 disc
+/ .
Select a track or
file
/ // .
Find a point in a
track or file
Hold down /  (or
/  on the unit) during
playback, and release the button at
the desired point.
Select Repeat Play REPEAT  repeatedly until “ ” or
“ 1” appears.
Eject a disc   on the unit.
To change the play mode
Press PLAY MODE  repeatedly while the player is
stopped. You can select Normal Play mode (“Normal” or
“FLDR” for all MP3 files in the folder on the disc),
Shuffle Play mode (“SHUF” or “FLDR SHUF*” for folder
shuffle), or Program Play mode (“PGM”).
* When playing a CD-DA (audio) disc, FLDR (SHUF) Play performs
the same operation as normal (SHUF) Play.
Notes on Shuffle Play mode
When Shuffle Play mode is set to “SHUF,” the system shuffle-plays
all tracks or files on the disc. When Shuffle Play mode is set to
“FLDR SHUF,” the system shuffle-plays all tracks or files in selected
folder.
When you turn off the system, the selected Shuffle Play mode
(“SHUF” or “FLDR SHUF”) is cleared and the play mode returns to
Normal Play mode (“FLDR”).
Notes on Repeat Play
“ ” indicates that all tracks or files will be repeated until you stop
playback.
“ 1” indicates that a single track or file will be repeated until you
stop playback.
Notes on playing MP3 discs
Do not save other types of tracks or files, or unnecessary folders on a
disc that has MP3 files.
Folders that have no MP3 files are skipped.
The system can only play MP3 files that have a file extension of
“.mp3.”
Even if a file name has the “.mp3” file extension, if the actual file
differs, playing it may generate loud noise that might even damage
the system.
The maximum number of:
 folders is 255* (including the root folder).
 MP3 files is 512.
 MP3 files in a single folder is 512.
 folder levels (in the tree structure of files) is 9.














 Power (DC IN 9.5 V)
1 Connect the AC adaptor to the unit.
2 Plug the AC adaptor into a wall outlet.
 AUDIO IN jack
Connect an external audio component.
 To AC Adaptor
 AM loop antenna
 FM lead antenna (Extend it horizontally.)
Unit (Top)
 Display panel
When the system is powered up, the setting status appears on the display panel.
When the system goes to Standby mode, the setting status disappears from the display panel.
Unit (Front)
Remote sensor
iPod/iPhone connector
CD door
(CD compartment)
Remote indicator
 Remote indicator
Lights in amber when a signal is received from the remote.
Remote
This manual mainly explains operations using the
remote, but the same operations can also be performed
using the buttons on the unit having the same or
similar names.
The SLEEP and TIMER MENU functions indicated in
pink on the remote can be activated using SHIFT .
If you want to operate the SLEEP or TIMER MENU
functions, press and hold SHIFT  and press SLEEP
 or TIMER MENU  button. If you press either
of these buttons without holding SHIFT  pressed,
the system will activate the BASS BOOST or SOUND
EFFECT function.


To use the remote
Remove the battery compartment lid, and insert the two
supplied R6 (size AA) batteries,  side first, matching
the polarities shown below.
Notes on using the remote
With normal use, the batteries should last for about 6 months.
Do not mix an old battery with a new one or mix different types of
batteries.
If you do not use the remote for a long period of time, remove the
batteries to avoid damage from battery leakage and corrosion.



Setting the clock
1 Press   to turn on the system.
2 Press and hold SHIFT  and TIMER MENU  to
select the clock set mode.
If “PLAY SET” flashes, press /  repeatedly to
select “CLOCK,” and then press (enter) .
3 Press  /  repeatedly to set the hour, then press
(enter) .
4 Use the same procedure to set the minutes.
Note
The clock settings are reset when you disconnect the power cord or if
a power failure occurs.
To display the clock when the system is off
Press DISPLAY . The clock is displayed for about
8 seconds.
 Antennas
Find a location and an orientation that provide good
reception, and then set up the AM antenna.
Keep the antenna away from the power cord to avoid
picking up noise.
Music discs encoded with copyright
protection technologies
This product is designed to playback discs that conform
to the Compact Disc (CD) standard. Recently, various
music discs encoded with copyright protection
technologies are marketed by some record companies.
Please be aware that among those discs, there are some
that do not conform to the CD standard and may not be
playable by this product.
License and Trademark Notice
iPhone®, iPod®, iPod nano®, and iPod touch® are
trademarks of Apple Inc., registered in the U.S. and
other countries. Lightning TM is a trademark of Apple
Inc.
MPEG Layer-3 audio coding technology and patents
licensed from Fraunhofer IIS and Thomson.
Windows Media is either a registered trademark or
trademark of Microsoft Corporation in the United
States and/or other countries.
This product is protected by certain intellectual
property rights of Microsoft Corporation. Use or
distribution of such technology outside of this product
is prohibited without a license from Microsoft or an
authorized Microsoft subsidiary.
All other trademarks and registered trademarks are of
their respective holders. In this manual, ™ and ® marks
are not specified.





4-462-380-11 (1)
Personal Audio System
GB Operating Instructions
©2013 Sony Corporation Printed in China
CMT-V10iPN