Sony KDF-55E2000 - Manual (Page 12)

masterpage:3 columns Right
12
D:\WINNT\Profiles\noriko\Desktop\SONY TROY 2\2681559131_Troy2
EN\2681559131\01US03WEL.fm
KDF-42E2000/KDF-46E2000/KDF-50E2000/KDF-55E2000
2-681-559-13(1)
Indicators
The indicators show the current status of your TV. If there is a change in the
condition or a problem with the TV, the indicators will flash or light up in
the manner described below to let you know that it requires your attention.
Projection Lamp Your TV uses a projection lamp as its light source. As with any lamp, it has a
lifespan and needs to be replaced when the Lamp indicator flashes or the
screen becomes darker. Your TV also has a function to display a message,
“Projection lamp is nearing end of life. Please replace the lamp.” to let you
know that the lamp has reached its expected lifespan. Note the following:
❑ After turning on your TV, it may take a while (1 minute or less) before
the picture appears.
❑ When the projection lamp wears out, the screen goes dark. Replace the
lamp with a new Sony XL-2400 replacement lamp (not supplied).
❑ After lamp is replaced, please set the “Lamp Replacement” option in the
Setup Settings (see page 76 and 73).
Indicator Flashing because...
POWER flashing green : The lamp for the light source is preparing to turn
on. When it is ready, the green indicator stays on.
red : The lamp door or the lamp is not securely attached.
The red indicator will continue to flash in intervals of three
blinks at a time until the lamp door or the lamp is placed
correctly. When the lamp door or the lamp is securely
attached, the TV will turn on with green indicator.
LAMP indicator
flashes The projection lamp has burned out. Replace it with new
one (see page 76).
TIMER indicator is
lit When one of the timers is set, the orange indicator will
remain lit (will not flash) even when the TV is turned off.
PUSH OPEN POWER/STANDBY POWER TIMER LAMP
Indicators
Screen
How to replace the lamp,
see page 76.
✍
The light emitted from the lamp is quite bright when your TV is in
use. To avoid eye discomfort or injury, do not look into the light
housing when the power is on.