Sony PFM-42B1S - Manual (Page 91)

39
(GB)
2
Press v / V to move the cursor (B) to “POWER
SAVING” and press ENTER.
The following menu appears on the display panel.
P O W E R S A V I N G : O F F
3
Press v / V to select the length of time until the
change to power saving mode.
OFF: The power saving function does not work.
5min: Changes to the power saving mode after
five minutes if there is no input signal.
10min: Changes to the power saving mode after
10 minutes if there is no input signal.
The ON indicator flashes when the unit is in the
power saving mode.
To cancel the power saving function
• Input the sync signal again.
• Press the 1 switch on the 1 (standby) switch /
indicator section or the POWER ON switch on the
Remote Commander.
Signal specification for using the power
saving function
The sync signal should be connected to the 13th pin of
the RGB/YUV (D-sub 15-pin) connector in the
INPUT1 or INPUT2 connectors.
On/Off Timer Function
1
In the CONFIG (1/2) menu, Press v / V to move
the cursor (B) to “POWER CONTROL” and press
ENTER.
The following menu appears on the display panel.
ENTER MENU
P O W E R C O N T R O L
P O W E R S A V I N G : O F F
O N / O F F T I M E R : O F F
S E L E C T S E T E N D
E N E R G Y S A V I N G : O F F
PFM-42B1/42B1E: “ENERGY SAVING” is not displayed.
Controlling Power On/Off Automatically (Power Control Function)
3
Press v / V to move the cursor (B) to “POWER
CONTROL” and press ENTER.
The following menu appears on the display panel.
ENTER MENU
P O W E R C O N T R O L
P O W E R S A V I N G : O F F
O N / O F F T I M E R : O F F
S E L E C T S E T E N D
E N E R G Y S A V I N G : O F F
4
Press v / V to move the cursor (B) to “ENERGY
SAVING” and press ENTER.
The following menu appears on the display panel.
E N E R G Y S A V I N G : O F F
5
Press v / V to select the ENERGY SAVING
Mode ON/OFF.
OFF: No energy saving
ON: energy saving
By enabling the ENERGY SAVING (ON), the
screen brightness is reduced and you can view the
display unit while saving energy.
Power Saving Function
1
In the CONFIG (1/2) menu, press v / V to move
the cursor (B) to “POWER CONTROL” and press
ENTER.
The following menu appears on the display panel.
ENTER MENU
P O W E R C O N T R O L
P O W E R S A V I N G : O F F
O N / O F F T I M E R : O F F
S E L E C T S E T E N D
E N E R G Y S A V I N G : O F F
PFM-42B1/42B1E: “ENERGY SAVING” is not displayed.