Ring connector – Sony PCV-E203 User Manual

Page 67

Advertising
background image

System Board

59

Ring Connector

The Ring connector (J20) is a 1 x 2-pin straight header that connects to the
wake signal (J3) from the fax/modem card to enable the phone ring
signal to wake the system from the sleep state.

This permits the system to go into the sleep state while monitoring the
fax/modem card for a ring signal. Upon receiving an incoming phone or
fax call, the ring signal on the fax/modem card wakes the system,
allowing unattended reception of voice or fax messages.

KY0060.VSD

J20

Advertising
This manual is related to the following products: