Sony bloggie MHS-PM5 - Manual (Page 16)

16
1 Preparing the battery pack
1
Open the battery/memory card cover and insert the battery pack into this
camera, then close the cover.
• Insert the battery pack as far as it will go, then press the back of the battery pack gently until it clicks.
• You cannot open the battery/memory card cover when a tripod is attached to the camera.
2
Open the USB jack cover, then slide the USB jack slide lever.
3
Connect the camera to the computer that is turned on with the USB
connection support cable (supplied).
• The Power/Charge lamp lights up in orange, and charging starts.
• When the Power/Charge lamp turns off, charging is finished.
• The Power/Charge lamp may turn off when the temperature is outside of the recommended operating
temperature (10 to 30°C.)
4
When charging is finished, disconnect the USB connection support cable
from the USB jack of your camera.
b Notes
• While the camera is connected to a computer, you cannot operate the camera. Be sure to disconnect the
camera before operation.
• Charging the battery with customized or hand-built computers is not guaranteed. Depending on the type of
USB device used, charging may not function properly.
Power/Charge lamp
USB connection support
cable (supplied)
USB jack slide
lever
USB jack
cover
AC Adaptor
Power cord (Mains lead)