Sony PCG-F450 - Manual (Page 3)

Owner’s Record
The model number and serial number are
located on the bottom of your Sony VAIO ®
Notebook. Record the serial number in the
space provided here. Refer to the model
and serial number when you call your
Sony Service Center.
Model Number: PCG-F430/PCG-F450
Serial Number:________________________
Safety Information
❏ To prevent fire or shock hazard, do
not expose your notebook computer
to rain or moisture.
❏ To avoid electrical shock, do not open
the cabinet. Refer servicing to
qualified personnel only.
❏ Never install modem or telephone
wiring during a lightning storm.
❏ Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
❏ Never touch uninsulated telephone
wire or terminals unless the telephone
line has been disconnected at the
network interface.
❏ Use caution when installing or
modifying telephone lines.
❏ Avoid using the modem during an
electrical storm.
❏ Do not use the modem or a telephone
to report a gas leak in the vicinity of
the leak.
❏ A socket outlet should be as close as
possible to the unit and easily
accessible.
❏ Pour prévenir tout risque d’incendie
ou d’électrocution, garder cet appareil
à l’abri de la pluie et de l’humidité.
❏ Pour prévenir tout risque
d’électrocution, ne pas ouvir le châssis
de cet appareil et ne confier son
entretien qu’à une personne qualifiée.
❏ L’appareil doit être le plus près
possible d’une prise murale pour en
faciliter l’accès.
Regulatory Information
.
!
To change the backup battery,
please contact your nearest Sony
Service Center.
WARNING
! For DVD-ROM: As the laser beam
used in the DVD-ROM drive is
harmful to the eyes, do not
attempt to disassemble the drive
cabinet. Refer servicing to
qualified personnel only.
AVERTISSEMENT
Declaration of Conformity
Trade Name: SONY
Model No: PCG-F430/PCG-F450
Responsible Party:
Sony Electronics Inc.
Address:
1 Sony Drive
Park Ridge, NJ 07656
Telephone No.: 201-930-6970
This device complies with Part 15 of
the FCC rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device
must accept any interference
received, including interference
that may cause undesired
operation.