Sony PCV-R528DS - Manual (Page 55)

Removing, Installing, and Replacing Components 47
Installing a 5¼” Internal Hard Disk Drive
Your system comes with an available 5¼” bay to hold an additional 3½”
or 5¼” hard disk drive. The drive you install can access the front panel.
The hard disk drive access light blinks when either internal drive is
active.
1
Configure the jumpers on the new drive as a secondary slave (see
your drive’s documentation for configuration instructions).
2
Disconnect the power cord from the computer.
3
Remove the cover (see “Removing the Cover” on page 24).
4
Remove the front panel (see “Removing the Front Panel” on page 26).
5 Lay the system on its side (see following diagram).
!
Before opening the system unit, save any open files, exit Windows, turn off
the power of the computer and all attached peripherals, and then unplug the
power cord.
KY0084.VSD
Drive connector
Power connector
Jumpers