Sony EBS-N100 - Manual

EBS-N100
Setup Guide
Purpose:
This document is a set up instruction guide for the EBS-N100 unit and using it with Display
Commander. Known issues of this pre-release version of Display Commander are included at the end
of the document.
Components:
1 - EBS-N100
1 – AC Adapter for EBS-N100
1 – RS232C cable
Loading Display Commander Software
The Display Commander software is included in an e-mail attachment. This software extends the
control set of the EBS-N100 from individual unit control to group controls.
Connections
Connecting EBS-N100 to Sony Professional Monitor
ETHERNET
COM1
POWER
5VDC
RGB RS232
EBS-N100
PLASMA DISPLAY
AUDIO IN
ETHERNET SWITCH/ROUTER
PORT 1 PORT 2 PORT 3 PORT 4 WAN
POWER
ADAPTOR
INTERNET
1) RS232C Cable
a. Attach the 9-pin RS232C Cable to the port
labeled “COM1” on the EBS-N100
b. Attach the other end to the REMOTE input on
the Sony Monitor
Connecting the EBS-N100 to a Network Router
1) CAT5 Cable
a. Plug the RJ45 connector into the back of the
EBS-N100
b. Plug the other end of the CAT5 cable into a
LAN port on the router
Power Up
1) Plug in the AC Adapter for the EBS-N100
Configuration
The EBS-N100 can be controlled and configured in two ways. The first is using the Display
Commander application to identify and control the EBS-N100 unit. The second is through an
embedded HTML Interface page for configuration and control.
Display Commander
Once power has been applied to the unit, double click on the Display Commander icon in the folder
where the application was extracted to from the Zip file. After a couple of seconds, the attached EBS-