Sony LBT-XGR600 - Manual (Page 28)

28 GB
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
1
Press x on deck B, TUNER ENTER and
?/1 at the same time.
2
Unplug the power cord.
3
Plug the power cord back in.
4
Press ?/1 to turn on the system.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.
One of the following messages may appear or
flash in the display during operation.
CD
CANNOT EDIT
The selected disc contains more than 20 tracks or
Program Play mode has been set.
NO STEP
You have cleared all the tracks you programed.
OVER
You have reached the end of the disc while pressing
M during playback or pause.
PUSH STOP
You have pressed PLAY MODE during playback.
STEP FULL
You tried to program 26 or more tracks (steps).
TAPE
NO TAB
You cannot record the tape because the tab has been
removed from the cassette.
NO TAPE
There is no tape in the tape deck.
Timer
OFF TIME NG
The Daily Timer or Timer Recording start and end
times are set to the same time.
Messages