Sony KDL-46HX820 User Manual

Page 105

Advertising
background image

The message [3D signal has been detected] automatically appears when 3D signal

is detected.

Deactivate the [3D Signal Notification] setting. Press HOME, then select

→ [Picture &

Display] → [3D Settings] → [3D Signal Notification] → [Off].

3D Glasses do not fit properly.

(The following adjustments apply only to TDG-BR100.)

Set both the switches on either side for a comfortable fit. Close the temple arms slightly

inwards to set the switch. ( )
Bend (adjust) the temple frames for a comfortable fit. ( )
Adjust the nose pad for your nose. ( )

LED indicator on the 3D Glasses flashes.

(The following illustration shows TDG-BR100.)

Flashes every few seconds: Indicates the glasses are powered on.
Flashes 3 times: Indicates the glasses have been powered off. The glasses turn off if you hold

the power button down for 2 seconds, or if no signal from the 3D Sync Transmitter is detected

for more than 5 minutes.
Flashes 3 times every 3 seconds: Indicates the battery capacity is almost running out. Replace

the battery, or charge the battery if the 3D Glasses have a rechargeable battery.

You cannot turn the 3D Glasses on.

Replace the battery. (Applies only to TDG-BR100/BR50. TDG-BR100 is used as an example in

the following instructions and illustrations.)

1. Open the battery cover using a coin, etc.
2. Push the edge of the battery and remove it at an angle.
3. Insert a battery (CR2032) with its positive (+) side facing up.
4. Close the battery cover using a coin, etc.
5. Make sure the cover is closed.

When opening or closing the battery cover, be sure to insert a coin, etc., into the slot.

LED Indicator

TDG-BR100

TDG-BR100

Coin, etc.

Battery (CR2032)

105

Advertising
This manual is related to the following products: