Sony LF-B10 - Manual (Page 15)

Se
tup a
nd Con
n
ec
tions
15
Attach the supplied IR Blaster to the device
connected to the Base Station.
You can control the device with the LocationFree
device’s on-screen remote control via the IR
Blaster.
With reference to the operating instructions of the
device, make sure to place the IR Blaster just
above or below the remote sensor. Remote
sensors on Sony Recorders and other products are
identified with the
symbol.
Note
Do not remove the backing paper from the IR Blaster
yet.
After configuring LocationFree Player remote control
settings (
1 “Configuring the LocationFree Player” in
“Part 2: LocationFree Player”), remove the backing
paper from the IR Blaster and fix it in place.
When operating two devices with the IR Blaster,
set the devices and the IR Blaster as shown.
If the infrared receivers on the two devices do not
line up like the illustration above, you need to
purchase an optional IR Blaster (VM-50, not
supplied) and install it.
Note
For details on setting up a device, refer to the operating
instructions of the device.
z Tips
• If the IR Blaster cable is too short, use the 3.5 mm
jack extension cable (not supplied).
• Remote sensors on Sony Recorders and other
products are identified with the symbol.
• You can set up two on-screen remote controls for
each video input connector. These on-screen remote
controls allow you to operate two devices connected
directly to the Base Station, and to control video
input via those devices. For more details, refer to
“Setting up the on-screen remote control” of
“Configuring the LocationFree Player” in “Part 2:
LocationFree Player”.
Connecting the IR Blaster
IR BLASTER
LAN
1 2
S VIDEO
IN 1
IN OUT
VIDEO
AUDIO
L
R
VIDEO
AUDIO
L
R
VIDEO
DC IN 12V
AUDIO
L
R
IN 2
OUT
IR Blaster
Infrared transmitter
Remote sensor
to IR BLASTER port
You can connect the
IR Blaster to either
port.
Rear of Base Station
IR Blaster
Remote sensors