Installing the software, To install movieshaker – Sony DCR-IP7BT User Manual

Page 11

Advertising
background image

11

Before Use

Installing the software

You need to install MovieShaker on your computer before using it.
Perform the following steps to install the program, after exiting all other
programs including anti virus software.

Notes

• Be sure to connect the MICROMV device to your computer after installing

MovieShaker. This will allow the computer to find it easily.

• If another version of MovieShaker is already installed, confirmation of the version

will be performed. Therefore, without uninstalling the previous version, install the
new version by clicking "Install MovieShaker 3.1," then follow the instructions on the
screen. (See the screen of step 2 in page 12)

• You need QuickTime 5 to use MovieShaker. If QuickTime 5 or later is not installed on

your computer, you need to install it in advance before installing MovieShaker 3.1.
(See page 16)

• You need DirectX 8.0a or later to use MovieShaker. If DirectX 8.0a or later is not

installed on your computer, you need to install it in advance. (See page 17)

• If you are running Windows 2000, be sure to log on as a user with administrative

privileges (such as "Administrator") to install MovieShaker.

To install MovieShaker

1

Insert the MovieShaker CD-ROM into the CD-ROM drive.

When the CD-ROM drive access lamp turns off, the "Setup MovieShaker
3.1 for MICROMV" dialog (dialogue) box appears.

Continued

Advertising
This manual is related to the following products: