Sony CDX-HS70MW - Manual (Page 5)

5
Getting Started
Resetting the unit
Before operating the unit for the first time, or
after replacing the boat’s battery or changing the
connections, you must reset the unit.
Open the front panel and press the RESET button
with a pointed object, such as a ball-point pen.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
Preparing the card remote
commander
Before using the card remote commander for the
first time, remove the insulation film.
Setting the clock
CDX-HS70MW/HS70MS:
12-hour indication
CDX-HR70MW/HR70MS:
24-hour indication
1
Press and hold (SELECT).
The setup display appears.
2
Press (SELECT) repeatedly until
“CLOCK-ADJ” appears.
3
Press (SEEK) +.
The hour indication flashes.
4
Rotate the volume control dial to set
the hour and minute.
To move the digital indication, press (DSPL).
5
Press (SELECT).
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press
(DSPL) again to return to the previous display.
With the card remote commander
In step 4, to set the hour and minute, press
M or m.
Tip
You can set the clock automatically with the RDS
feature (page 11). (CDX-HR70MW/HR70MS only)
Inserting the disc in the unit
1
Slide the OPEN switch in the direction
of the arrow.
2
Open the front panel.
3
Insert the disc (label side up).
4
Close the front panel.
Playback starts automatically.
Notes
• Do not put anything on the inner surface of the front
panel.
• Be sure to close the front panel during operation.
Ejecting the disc
1
Slide the OPEN switch and open the
front panel.
2
Press Z.
The disc is ejected.
3
Close the front panel.
RESET
button