Time code/user bit – Sony HDR-AS100VR User Manual
Page 29
Ta
bl
O
Set
In
29
GB
Time Code/User Bit
You can use the time code/user bit when [PRO] is set to [ON].
You can set the following settings from [TC/UB].
To make the setting, select [SETUP] first.
1 Press the NEXT button to display [SETUP], then press the ENTER button.
2 Press the NEXT button to display [TC/UB], then press the ENTER button.
3 Press the NEXT button to select [TCSET] or [UBSET], then press the
ENTER button.
4 Press the NEXT button to select the setting, then press the ENTER
button.
Sets the time code.
• Set four 2-digit numbers, then press the ENTER button.
• The time code can be selected within the following range.
– When selecting 30p or 60p
00:00:00:00 (default) - 23:59:59:29
– When selecting 25p or 50p
00:00:00:00 (default) - 23:59:59:24
• When selecting 24p, you can set the last 2 time code digits of the
frames in multiples of 4, between 0 and 23.
Initializes the time code.
• Press the ENTER button to display [SURE?] while [OK] is displayed,
then press the ENTER button again.
Selects the time code recording method.
DF
Records the time code in drop frame (default).
NDF
Records the time code in non-drop frame.
• In the following situations, time code is recorded in [NDF], and
[FORMT] will not be displayed.
– When [VMODE] is set to 24p
– When [V.SYS] is set to [PAL]
Sets how the time code advances.
REC
The time code advances only while recording XAVC S movies.
It is recorded sequentially from the time code on the image
recorded last time (default).
FREE
The time code advances sequentially, regardless of the operation
of the camera.
Sets the recording time code.
PRSET The newly set-up time code is recorded on recording media
(default).
REGEN The last time code of the previous recording is read out from the
recording media and the new time code is recorded sequentially
from the last time code.
• The time code advances in [REC] mode regardless of the setting of
[RUN].
Returns to the [TCSET] menu.
t
Setting
display
Continued
r