Step 5: turn on the monitor and computer, Adjusting the tilt – Sony SDM-HS95B User Manual

Page 9

Advertising
background image

9

GB

Step 5: Turn on the monitor and

computer

1

Press the 1 (power) switch upward.
The 1 (power) indicator of the monitor lights up in green.

2

Turn on the computer.

The installation of your monitor is complete. If necessary, use the
monitor’s controls to adjust the picture.

If no picture appears on your screen

• Check that the power cord and the video signal cable are

properly connected.

If NO INPUT SIGNAL appears on the screen:

The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.

If CABLE DISCONNECTED appears on the screen:

Check that the video signal cable is properly connected.

If OUT OF RANGE appears on the screen:

Reconnect the old monitor. Then adjust the computer’s
graphics board within the following ranges.

For more information about the on-screen messages, see “Trouble
symptoms and remedies” on page 18.

No need for specific drivers
The monitor complies with the “DDC” Plug & Play standard and
automatically detects all the monitor’s information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.

The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.

Adjusting the tilt

This display can be adjusted within the angles shown below.

Grasp the lower sides of the LCD panel, then adjust screen tilt.

To use the display comfortably

This display is designed so that you can set it up at a comfortable
viewing angle. Adjust the viewing angle of your display
according to the height of the desk and chair, and so that light is
not reflected from the screen to your eyes.

Note
When adjusting the screen tilt, make sure not to knock or drop the display
off the desk.

SDM-HS75

SDM-HS95

Horizontal
frequency

28–80 kHz

28–80 kHz

Vertical
frequency

48–75 Hz

48–75 Hz

Resolution

1280

× 1024 or less 1280 × 1024 or less

Approx. 20°

Advertising
This manual is related to the following products: