Sony SU-XWQ005 - Manual (Page 10)

8
(US)
Step 5: Install the
Display Unit
WARNING
Be sure to complete the installation before
connecting the AC power cord to the wall outlet. If
you allow the AC power cord to be pinched under
or between pieces of equipment, this may result in
a short circuit or an electric shock.
Be careful not to stumble over the AC power cord
or the Display Unit, as you may hurt yourself.
1
Attach the Mounting Hook Unit
on the hooks on the rear side of
the Display Unit. Then slide the
Mounting Hook Unit, as
illustrated below, and fix it
using the supplied screws (M5
×
L16).
2
Connect the AC power cord and
the display interface cable
supplied with the Display Unit
to the Display Unit.
Connect the AC power cord and the display
interface cable to the connectors on the rear side
of the Display Unit. For details on connecting
the AC power cord and the display interface
cable, refer to the Operating Instructions
supplied with the Display Unit.
When you route the cable and the cord behind
the wall, feed them through the hole you drilled
(page 12).
Notes
• Once you install the Display Unit to the Plate Unit,
you cannot connect the cord and the cables.
• Be sure to subcontract the routing of the cable
behind the wall and electrical work to qualified
contractors.
Screw (supplied M5 × L16)
Mounting Hook Unit
Soft cloth Rear side of Display Unit
Thread the cable through here.