Sony HDR-SR10 - Manual (Page 76)

76
GENERAL SET
(Other setup items)
Touch 1, then 2.
If the item is not on the screen, touch
/
to change the page.
How to set
(HOME MENU) t page 64
(OPTION MENU) t page 78
The default settings are marked with B.
The default setting is [ON], allowing you to
view the demonstration in about 10
minutes, after you turn the POWER switch
to
(Movie).
z Tips
• The demonstration will be suspended in
situations such as those described below.
– When you press START/STOP or PHOTO
– When you touch the screen during the
demonstration (The demonstration starts
again after about 10 minutes)
– When you set the POWER switch to
(Still)
– When you press (HOME) or (VIEW
IMAGES)
The camera recording lamp on the front of
your camcorder lights up, as the default
setting is [ON].
See page 104.
DEMO MODE
REC LAMP (Recording
lamp)
CALIBRATION
B 5 min
The camcorder is automatically turned off
when you do not operate your camcorder
for more than approximately 5 minutes.
NEVER
The camcorder is not automatically turned
off.
b Notes
• When you connect your camcorder to a wall
outlet (wall socket), [A.SHUT OFF] is
automatically set to [NEVER].
You can set the time that you want the
camcorder to remain on before turning off
in sleep mode (p. 32). The default setting is
[10min].
b Notes
• [A.SHUT OFF] does not work during sleep
mode.
The default setting is [ON], allowing you to
use the supplied Remote Commander
(p. 111).
z Tips
• Set to [OFF] to prevent your camcorder from
responding to a command sent by another VCR
remote control unit.
When the drop sensor has detected that the
camcorder has been dropped, your
camcorder may not allow you to record and
play back correctly to protect the internal
hard disk, as the default setting is [ON].
When dropping is detected,
appears.
A.SHUT OFF (Auto shut
off)
QUICK ON STBY (Quick
on standby)
REMOTE CTRL (Remote
control)
DROP SENSOR