Additional information, Precautions troubleshooting, Troubleshooting – Sony HT-6600DP User Manual

Page 43: Precautions

Advertising
background image

Additional Information

43

US

HT-6600DP 4-244-560-11(1) US

Additional Information

If you encounter color irregularity on a nearby
TV screen

This speaker system is magnetically shielded to
allow it to be installed near a TV set. However,
color irregularities may still be observed on certain
types of TV sets.

If color irregularity is observed...

Turn off the TV set once, then turn it on again after
15 to 30 minutes.

If color irregularity is observed again...

Place the speaker further away from the TV set.

If howling occurs

Reposition the speakers or turn down the volume
on the receiver.

On cleaning

Clean the cabinet, panel and controls with a soft cloth
slightly moistened with a mild detergent solution. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.

If you have any question or problem concerning your
receiver, please consult your nearest Sony dealer.

Troubleshooting

If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem. Also, see “Checking the connections”
on page 21 to verify that the connections are
correct.

Precautions

On safety

Should any solid object or liquid fall into the cabinet,
unplug the receiver and have it checked by qualified
personnel before operating it any further.

On power sources

• Before operating the unit, check that the operating

voltage is identical with your local power supply.
The operating voltage is indicated on the nameplate
at the rear of the receiver.

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the wall
outlet, even if the receiver itself has been turned off.

• If you are not going to use the receiver for a long

time, be sure to disconnect the receiver from the
wall outlet. To disconnect the AC power cord,
grasp the plug itself; never pull the cord.

• (Models of area code U, CA only)

One blade of the plug is wider than the other for the
purpose of safety and will fit into the wall outlet
only one way. If you are unable to insert the plug
fully into the outlet, contact your dealer.

• AC power cord must be changed only at the

qualified service shop.

On heat buildup

Although the unit heats up during operation, this is
not a malfunction. If you continuously use this unit at
a large volume, the cabinet temperature of the top,
side and bottom rises considerably. To avoid burning
yourself, do not touch the cabinet.

On placement

• Place the receiver in a location with adequate

ventilation to prevent heat buildup and prolong the
life of the receiver.

• Do not place the receiver near heat sources, or in a

place subject to direct sunlight, excessive dust or
mechanical shock.

• Do not place anything on top of the cabinet that

might block the ventilation holes and cause
malfunctions.

• Use caution when placing the unit or speakers on

surfaces that have been specially treated (with wax,
oil, polish, etc.) as staining or discoloration of the
surface may result.

On operation

Before connecting other components, be sure to turn
off and unplug the receiver.

continued

Advertising