Sony PCG-FX140K - Manual (Page 3)

3
intended for home and other limited viewing
uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering
or disassembly is prohibited. i.LINK is a SONY
trademark used only to designate that a product
contains an IEEE 1394 connector. All products
with an i.LINK connector may not
communicate with each other.
All other trademarks are trademarks of their
respective owners.
Owner’s Record
The model number and serial number are
located on the bottom of your Sony VAIO®
Notebook. Refer to the model and serial
number when you call your Sony Service
Center.
Model Numbers: PCG-9512, PCG-9522, PCG-
9532, PCG 9542, PCG-9552, PCG-951A,
PCG-952A, PCG-953A, PCG-954A, PCG-
955A
Serial Number:________________________
Safety Information
WARNING
❑ To prevent fire or shock hazard,
do not expose your notebook
computer to rain or moisture.
❑ To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualified personnel only.
❑ Never install modem or telephone
wiring during a lightning storm.
❑ Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
❑ Never touch uninsulated
telephone wire or terminals
unless the telephone line has been
disconnected at the network
interface.
❑ Use caution when installing or
modifying telephone lines.
❑ Avoid using the modem during an
electrical storm.
❑ Do not use the modem or a
telephone to report a gas leak in
the vicinity of the leak.
❑ A socket outlet should be as close
as possible to the unit and easily
accessible.
AVERTISSEMENT
! To change the backup battery,
please contact your nearest Sony
Service Center.
! Caution - The use of optical
instruments with this product will
increase eye hazard. As the laser
beam used in this product is
harmful to the eyes, do not
attempt to disassemble the
cabinet. Refer servicing to
qualified personnel only.
! For CD-RW/DVD-ROM drive,
DVD-ROM drive: Danger - Visible
and invisible laser radiation when
open. Avoid direct exposure to
beam.
! Caution: To reduce the risk of fire,
use only No. 26 AWG or larger
telecommunication line cord.