ATTO Technology 1500D/E - Manual (Page 17)

8
Installation: ATTO iPBridge 1550E
Exhibit 1.3-1 iPBridge 1550E board layout
Exhibit 1.3-2 iPBridge 1550E board profile and dimensions
Installation instructions
1 Install the iPBridge 1550E in the target device
using the mounting holes in the board. (See the
board layout diagram in Exhibit )
2 Connect SCSI devices to the iPBridge. (See
Connecting SCSI devices to the SCSI port on
page 11)
3 Connect the iPBridge to your SAN: attach CAT
6 or CAT 5E cables to the Ethernet port on the
iPBridge or connect an RJ11 and adapter
crossover serial cable (null modem) between
the iPBridge serial port and one of the
computer's serial COM ports.
4 Connect the power connector and power up.
5 Boot the computers on the SAN.
6 Access iPBridge Services via the Ethernet port.
(See
Configuring the iPBridge on page 13) or
the serial port ( Connecting using the serial port
on page 14)
7 Verify that the bridge can be accessed on the
local Ethernet network by using the
Ping utility.
(See Step 7 on page 15)
8 Set up the configuration for the devices
connected to the iPBridge (See
Managing the
iPBridge on page 17.)
9 Power cycle the iPBridge. The iPBridge will
automatically map the devices on startup
Mounting hole
Mounting hole
Mounting hole
Mounting hole
Mounting hole
SCSI port
Ethernet port
SCSI Activity LED
Reset
Serial port
4-pin
power
connector
SCSI Activity
LED
Fault LED
SCSI Activity
LED
pin 1
. 3 4 3
. 5 3 6
. 3 1 3
L o n g B o a r d E d g e
E t h e r n e t P o r t S C S I P o r t P o w e r
. 3 3 1
. 2 7 6 S h o r t B o a r d E d g e
E t h e r n e t P o r t R J - 1 1 P o r t - 1 1 P o r t
. 3 4 3
. 5 3 6
. 3 1 3
. 3 4 3
. 5 3 6
. 3 1 3
L o n g B o a r d E d g e
E t h e r n e t P o r t S C S I P o r t P o w e r
. 3 3 1
. 2 7 6 S h o r t B o a r d E d g e
E t h e r n e t P o r t R J - 1 1 P o r t - 1 1 P o r t
. 3 3 1
. 2 7 6
. 3 3 1
. 2 7 6 S h o r t B o a r d E d g e
E t h e r n e t P o r t R J - 1 1 P o r t - 1 1 P o r t R J - 1 1 P o r t - 1 1 P o r t