ATTO Technology 1500D/E - Manual (Page 28)

19
ATTO Technology Inc. iPBridge Installation and Operation Manual
2.1 ExpressNAV provides web-based interface
Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters
based on a specific topic.
ATTO ExpressNAV is the recommended
management tool for the iPBridge. It is a web-
based graphical user interface (GUI) that allows
you to manage the iPBridge by clicking choices
and commands in traditional GUI fashion or by
entering CLI commands directly, as you would in
a terminal emulation session.
Before opening an ExpressNAV session, you
must install the ExpressNAV interface. Refer to
Configuring the iPBridge on page 13.
To open an ExpressNAV session
1 Point your browser at the IP address of the
iPBridge. Refer to
Configuring the iPBridge on
page 13.
2 The ExpressNAV home page is displayed.
Click Enter.
3 Enter the username and password values.
Note
The default values are username: “root” and
password: “Password”. The username is case
insensitive and password is case sensitive.
The Status page appears.
Each page can be reached through the menu at the
side of each page An image on each page’s header
shows each port in the product faceplate. Each
port is clickable and will also take you to the
appropriate page.
Status
Displays iPBridge information
• Vendor ID
• Product ID
• Firmware revision number
• Serial
number
• Ethernet port IP addresses
• Ethernet port status
Serial Port Configuration
Configure the baud rate and echo parameters. See
Serial port configuration commands on page 33
for details on each option.
Ethernet Port Configuration
Configures each port independently for the
following parameters
• Enable/disable DHCP
• IP address
• IP gateway
• IP subnet mask
• Ethernet
speed
• MTU
Note
Ethernet speed settings in the host must be
the same as Ethernet speed settings in the
iPBridge. The iPBridge default Ethernet speed
is auto: your host must be set to auto. If you set
Ethernet speed to 10, your host must be set to
Ethernet speed 10, half duplex. If you set
Ethernet speed to 100, your host must be set
to Ethernet speed 100, half duplex.
See Ethernet commands on page 35 for details on
each parameter.
SCSI Configuration
Displays include a list of attached devices for the
SCSI bus. Configurable options are
• Port Bus Speed
• Synchronous
Transfer
• Wide Transfer
• Initiator ID
• Bus Reset on Startup
• Bus
Termination
• SCSI Port Reset
See SCSI configuration commands on page 31
for details on each parameter.